The Spiral Tool can be used to draw Archimedes' spirals. Other types of spirals can be drawn using the Function Plotter extension with polar coordinates. Select the tool by clicking on the icon (F9 or i) in the Tool Box. To draw a spiral, use a Left Mouse Drag. The start of the drag will be the spiral's center. Holding down the Ctrl key while dragging will constrain the position of the spiral end point to a multiple of the Rotation snap angle (default 15 degrees). To reverse the direction of the spiral, flip it ( → (H) or → (V)).
Spirals can be reshaped by either dragging handles (small diamonds) on the spiral or by using the settings in the Tool Controls when the Spiral Tool is selected. There are two handles, the Inner and Outer. Dragging either handle allows rolling and unrolling the spiral from its respective end (i.e., making the spiral longer or shorter, or changing the radius of the inner and outer ends). Holding down the Ctrl key forces the end to be at a multiple of the Rotation snap angle with respect to the center. Holding down the Shift key while clicking on the Inner handle will set the inner radius to zero.


The Inner handle can also be used to change the divergence of the spiral by dragging the handle up or down while holding down the Alt key. The divergence is a measure of how rapidly the radius changes with respect to the angle as the spiral progresses. A divergence of one gives a spiral where the distance between successive turns remains uniform (an Archimedes' spiral). Divergences smaller (larger) than one give a spiral where the distance between successive turns decreases (increases) moving outward. Mathematically, the radius of a point is proportional to its angle (measured in radians) raised to a power equal to the divergence. Clicking on the Inner handle while holding down the Alt key will reset the divergence to one.


The Outer handle can be used to scale and rotate the spiral by dragging it with the Shift key pressed. If both the Shift and Alt keys are held down, then the spiral will only rotate, keeping the radius fixed.
The number of turns, divergence, and inner radius can all be set in the Tool Controls. These values can also be reset to their default values by clicking on the Defaults button ( ).
To understand the Fill of spiral one must understand how Inkscape calculates Fill. This is covered in detail in Chapter 10, Attributes. A spiral is basically an open path. The Fill is drawn as if the path was closed with a line segment between the path ends (the Inner and Outer handles). Then the current Fill Rule is applied.
How do you completely fill a spiral with the Evenodd fill rule? The trick is to use a second duplicate spiral, with one less turn (drag Outer handle to unwind the spiral one turn).
© 20052015 Tavmjong Bah.  Get the Book or EBook. 